SWAT Link

Step 1 - Setup your swat Project

Step 2 – Go to Project folder

• There go to scenarios\default (example: C:\AVS2000\mulargia1\scenarios\default)

• In the default folder create a folder named RES

Step 3 - Copy the ascii file named “nomfich.dat” • copy the ascii file named “nomfich.dat” in to the folder ..\scenarios\default\txtinout

Step 4 - Copy the executable SWAT.EXE • Copy the executable SWAT.EXE to the txtinout folder • Use SWAT2000 or SWAT2005 depending on the version of your SWAT project. Do not run SWAT2005 in a SWAT2000 and vice versa

Step 5 – Copy the ascii file called “outputs.dat” • Copy the ascii file called “outputs.dat” in folder ..\scenarios\default\res

SWAT_WITH_CHANGES : 1

SUBBASIN_OUT  : 1 METEO_OUT  : 0 PLANTS_OUT  : 0 NITRATE_OUT  : 0 REACHES_OUT  : 0 GLOBAL_WATER_OUT  : 0 USLE_OUT  : 0 GLOBAL_NUTRIENTS_OUT : 0

SUBBASIN_TIME_SERIE_LOCATION : ..\res\TS_SubBasin.dat

Step 6 – Copy the ascii file called “TS_SubBasin.dat” • Copy the ascii file called “TS_SubBasin.dat” in folder ..\scenarios\default\res with the following key words

DT_OUTPUT_TIME  : 43200. MAX_BUFFER_SIZE  : 1000.

<BeginTimeSerie> LOCALIZATION_I  : 1 <EndTimeSerie>

<BeginTimeSerie> LOCALIZATION_I  : 2 <EndTimeSerie>

(…)

<BeginTimeSerie> LOCALIZATION_I  : MaxNumberOfSubasins <EndTimeSerie>

• Repeat this step to the other Time Serie files: ts_global.dat, ts_hru.dat, ts_subbasin.dat Step 6 – Run MOHID Swat executable • Run the executable you copied to txtinout Step 7 – Vizualize output using Mohid time serie editor

Step 7 – Make statistic analysis using mohid statistic analyzer

• Load the observed data file and the rch swat output file: